USER'S MANUAL FOR INDUCTION TEPPAN cod.
Dear customer, Thank you for having chosen our induction ceramic hob. In order to make the best use of your appliance, we would advise you to read carefully the following notes and to keep them for a later consulting. SUMMARY SAFETY..................................................................................................................................... 15 PRECAUTIONS BEFORE USING....................................................................................................
SAFETY Precautions before using Unpack all the materials. The installation and connecting of the appliance have to be done by approved specialists. The manufacturer can not be responsible for damage caused by building-in or connecting errors. To be used, the appliance must be well-equipped and installed in a kitchen unit and an adapted and approved work surface.
Precautions not to damage the appliance Raw pan bottoms or damaged saucepans (not enamelled cast iron pots,) may damage the ceramic glass. Sand or other abrasive materials may damage ceramic glass. Avoid dropping objects, even little ones, on the vitroceramic. Do not hit the edges of the glass with saucepans. Make sure that the ventilation of the appliance works according to the manufacturer’s instructions. Do not put or leave empty saucepans on the vitroceramic hobs.
DESCRIPTION OF THE APPLIANCE Technical data Type Total Power Heating zone location Nominal Power* 7325440 2800W Front Rear 1400W 1400W * Average measured power Control panel Control light timer Locking key Locking light Timer / Power display On / Off key [ - ] key Timer key [ + ] key USE Sensitive touches Your ceramic hob is equipped with electronic controls with sensitive touch keys. When your finger touches the key, the corresponding command is activated.
Ventilation The cooling system is fully automatic. The cooling fan starts with a low speed when the calories brought out by the electronic system reach a certain level. The ventilation starts his high speed when the hob is intensively used. The cooling fan reduces his speed and stops automatically when the electronic circuit is cooled enough. STARTING-UP AND APPLIANCE MANAGEMENT Before the first use Clean your hob with a damp cloth, and then dry the surface thoroughly.
Timer The timer is able to be used with a time setting from 0 to 99 minutes.
COOKING ADVICE Setting up the cooking levels / temperatures Cooking levels 1 2 3 4 5 6 7 8 9 Temperature (°C) 50 75 100 125 150 170 190 205 220 You can cook directly on the heating surface with or without fat (oil or grease) Avoid reaching the « smoking point » (too high temperature) when you are cooking with oil or fat. Food will lose its nutritive value. In order to conserve all the flavour and quality, be sure to adjust the right temperature in accordance with the type of cooking required.
MAINTENANCE AND CLEANING Glass cleaning Clean the control panel using a little washing up liquid diluted in water or a recommended commercial vitroceramic product. Highly corrosive or abrasive detergents and cleaning equipment likely to cause scratches must be avoided at all costs. Dry the appliance with a clean rag. Spillages of sugar, jam, jelly, etc. must be removed immediately.
WHAT TO DO IN CASE OF A PROBLEM The hob or the cooking zone doesn’t start-up The hob is badly connected on the electrical network. The protection fuse cut-off The locking function is activated The sensitive keys are covered of grease or water. An object is put on a key. The symbol [ E ] displays Disconnect and replug the hob. Call the After-sales Service. One or all cooking zones cut-off The safety system functioned You forgot to cut-off the cooking zone for a long time.
INSTALLATION INSTRUCTIONS The installation comes under the exclusive responsibility of specialists. The installer is held to respect the legislation and the standards enforce in his home country. How to stick the gasket The gasket supplied with the hob avoids all infiltration of liquids in the cabinet. His installation has to be done carefully, in conformity of the following drawing. Stick the gasket (2) two millimeters from the external edge of the glass, after removing the protection sheet (3).
ELECTRICAL CONNECTION The installation of this appliance and the connection to the electrical network should be entrusted only to an electrician perfectly to the fact of the normative regulations and which respects them scrupulously. Protection against the parts under tension must be ensured after the building-in. The data of connection necessary are on the stickers place on the hob casing near the connection box.
cod. 9606885 Foster spa 42041 Brescello (RE) - Italy tel. +39.0522.687425 - tel. Servizio Assistenza +39.0522.684450 fax +39.0522.686019 - fax Servizio Ricambi +39.0522.962166 e-mail: service@fosterspa.com www.fosterspa.
