User Guide

30
Safety functions and error display.
ERROR CODE
ERROR DESCRIPTION
INSTRUCTION MANUAL
FA
Anomaly of infrared signal, of on/off key -
all cooking zones are deactivated
CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
FC
Receiver infrared anomaly of button
on/off - all cooking zones are deactivated
CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
FE
Touch control ntc sensor: short circuit on
ntc sensor.- all cooking zones are
deactivated
CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
FT
Touch control ntc sensor: ntc sensor
opening - all cooking zones are
deactivated
CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
Fc
Touch control ntc sensor: ntc sensor
overheating - all cooking zones are
deactivated
Switch the hob off and in case also the
underbuilt-in ofen since completely
cooling. Turn on the hob to check all
functions. If the problem remains
CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
FH
Eprom (memory) of Touch control:
anomaly of touch control eprom. - All
cooking zones are deactivated
CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
FJ
Anomaly of adc, of on/off key - all
cooking zones are deactivated
CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
FO
Touch Control Sotware: anomaly on the
touch control software. - All cooking
zones are deactivated
CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
FL
Touch Control luminosity: excessive
external luminosity that hampers t/c
sensors (push buttons) calibration - All
cooking zones are deactivated
Remove or replace the external
luminosity source. If the problem remains
despite the calibration conditions have
been respected : CONTACT
AUTHORIZED CENTER FOR
TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
FU
Touch Control Divider: anomaly on the
t/c Divider. - All cooking zones are
deactivated
CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
F5
Anomaly in the communication between
touch and power board - - all cooking
zones are deactivated an error is
visualised on all displays
CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
F1
Short circuit of temperature sensor of
heating elements - the only cooking zone
with the anomaly is deactivated - and
error is visualised on the relating display
CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
F2
Opening of ntc sensor- the only cooking
zone with the anomaly is deactivated -
and error is visualised on the relating
display
CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
F8
Anomaly on the NTC sensor - the only
cooking zone with the anomaly is
deactivated - and error is visualised on
the relating display
CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
F7
Anomaly on the NTC sensor - the only
cooking zone with the anomaly is
deactivated - and error is visualised on
the relating display
CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
F9
Over-current generator - all cooking
zones are deactivated an error is
visualised on all displays
CONTACT AUTHORIZED CENTER
FOR TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
Alternate flashing of cooking
level set by user and of the
letter “C”
Over-temperature of generator due to
intensive use or another use different
from domestic use
IF HOLD OVER, CONTACT
AUTHORIZED CENTER FOR
TECHNICAL ASSISTANCE -
SPECIFYING THE ERROR CODE
F3
Short circuit of NTC sensor - all cooking
CONTACT AUTHORIZED CENTER