DVD Location Recorder

62
Location Recorder Model PD204
Chapter 4: Basic connections
5.0(A )XAM
V42-21
NI-CD
V42-21
UO-CDT
DBYK
TSOH
CP
BSU
L IN OUTR
ADJUST
DIGITAL
ANALOG OUT
1:GND
1:GND
2:NC
3:NC
4:12-24V
1:GND
2:NC
3:NC
4:12-24V
2:HOT
3:COLD
XLR
DC-IN DC-OUT
PELLARAL
ETOMER-P9
UOT
DROW
NI
OEDIV
/DROW
UAT ES OL
FFONO
EDOC EMIT
NITUO
1234
RL
NI GOLANA
TSUJDA
AUX IN
The PD204 provides four analog mic/line input channels (channels 1 through 4).
The balanced XLR-3-31 type connector on each channel accepts a wide range of
audio signal level from mic to line.
Each channel provides the input selector (LINE or MIC), power supply for micro-
phone, limiter circuit and HPF (high pass filter). The power supply for microphone
supports both phantom power (P48) and A-B power (T12) which allows the PD204
to accept various condenser microphones.
The limiter threshold and ratio can be adjusted using the "Limiter parameter" item
in the "SYS SETUP" menu of the MENU mode (see page 156).
As for the HPF, you can adjust the cutoff frequency and select the slope curve.
To record an analog audio signal, follow the procedure below (for details, see "Chapter
5: Recording/Playback").
1) Set the [INPUT SEL] switch on the top panel to the appropriate position (LINE
or MIC) according to the input source.
2) Select the Microphone power switch appropriately when you use a microphone.
3) Connect an analog source to the [ANALOG IN] connector.
Input connection
Analog audio signals (mic/line)
Analog audio input connection
Digital audio signals
External time code
Sync signal
Analog audio signals