DVD Location Recorder

Location Recorder Model PD204

Chapter 5: Recording/Playback

You can select a sampling frequency and bit length combination.

Sampling frequency and bit length selection [ ]

<Note>:

When the system clock is set to "DIGI" or "WORD", the FS of a file to be played

back must match the FS setting of the unit. Otherwise, you cannot play back the file.

In such a case, make the FS setting of the unit to match the FS of the file.

<Note>:

If you change the FS/BIT setting during recording, the new setting is not

valid until recording stops.

You can select a sampling frequency and bit length combination also via the "Record FS&Bit"

menu item in the "SYS SETUP" menu of the MENU mode (see page 142 for details).

Available FS/BIT options (default: 48/24)

44.1/16, 44.1/24, 48/16, 48/24, 88.2/24, 96/24, 176.4/24, 192/24

You can select the recording mode of the LTC generated by the internal TC generator or

external time code.

TC generator mode setting (TC recording mode) [ ]

You can make the pull up/pull down setting of the sampling clock/internal TC frame rate

when the clock reference is set to "INT".

Clock pull up/pull down setting [ ]

<Note>:

You can set the default LTC start time via the "Default LTC Start" menu item

in the "TC SETUP" menu of the MENU mode (see page 184).

<Note>:

You cannot make pull up or down setting when the time code frame rate is

set to 25 fps. If you select "+0.1%" or "-0.1%" when the frame rate is set to 25 fps,

"+0.1%" or "-0.1%" is shown in the "UP/DW" field.

You can also select the TC recording mode via the "Gen mode" menu item in the "TC SETUP"

menu of the MENU mode (see page 177).

Available TC recording mode options (default: Rec-Run)

FREE (Free Run), Rec-R (Rec-Run), 24H-R (24H-Run), EXT (Ext Run)

Available pull up/pull down options (default: 0.0%)

+0.1%, 0.0%, -0.1%

You can also make the pull up/pull down setting via the "Pull up/down" menu item in the

"SYS SETUP" menu of the MENU mode (see page 143 for details).

<Note>:

The sampling frequency of the digital input signal must match the Fs/Bit

setting of the PD204.