DVD Location Recorder

78
Location Recorder Model PD204
Chapter 5: Recording/Playback
During recording, if the unit encounters the following problems, the error tone is output for
warning.
1. A write error happens during recording.
2. The input amplifier is clipped during recording.
3. The battery voltage drops below the specified level.
4. The remaining volume of a disk (or partition) becomes less than the specified volume.
You can make error tone output setting via the "Error tone" item in the "SYS SETUP" menu of
the MENU mode (see page 160).
Error tone output setting
Mixer settings
The mixer section provides the function for mixing four analog input sources to the stereo bus.
You can record the stereo bus signals to stereo L/R tracks. (When you record a digital input
signal, the signal is directly recorded to the stereo L/R tracks without being routed to the mixer
section.)
The four input channels of the mixer section provide controls for the analog input signal,
including the filter, limiter, etc.
The following diagram shows the signal flow of the mixer section of the PD204.
Read the explanation described in the following pages and make mixer settings appropriately.
P48V
T12V
LINE/MIC
AMP
GAIN
LIMITER
HPF
PHASE
ST BUS
SEND
PAN
ST BUS
MASTER
LIMITER
REPRO/
INPUT
SEL
MONITOR
SEL
DA
DA
FROM RECORDER
(REPRO DATA)
ANALOG OUT
TO HP/MON SP
ANALOG IN 1-4
AD
DA
LEVEL
SEL
AUX IN L, R
PFL
TO RECORDER
(2TRK FILE)