Network Adapter Owner's Manual

211
Location Recorder Model PD606
Chapter 8: MENU mode/DISK UTILITY menu
Using the "Part. protect" menu item, you can select "On" or "Off" of the software protection
(record inhibit) for the current partition.
The following procedure assumes that a partition you want to make protection setting is se-
lected as the current drive.
Partition protection On/Off setting [Part. protect]
<Note>: When a protected partition is loaded, the " " icon is shown on the Home display
as well as the DRIVE SEL display as shown below.
<Note>: If a partition is not selected as the current drive, "---" is shown.
4) Use the [MENU] dial to select "On" or "Off", and press the [ENTER/YES] key to confirm your
setting.
5) Press the [EXIT] key repeatedly until you exit the MENU mode.
3) Use the [MENU] dial to select the "Part. protect" menu item and press the [ENTER/YES] key.
The current option ("On" or "Off") starts flashing (the default is "Off") and you can now
select the desired option.
1) While the unit is stopped, press the [SHIFT] key to light the [SHIFT] indicator, followed by
the [ENTER/YES] key.
The unit enters the MENU mode and the MENU list screen is shown.
2) Use the [MENU] dial to select the “DISK UTILITY” menu and press the [ENTER/YES] key.
The display now shows the DISK UTILITY menu screen.
Flashing