Network Adapter Owner's Manual

46
Location Recorder Model PD606
Chapter 3: Names and Functions
3. [QUICK SET] key
Pressing this key enters the quick setup mode. In this mode, you can
directly select the setting items shown in the status indication area on
the Home screen (see page 74 for details).
To cancel the quick setup mode, press the [EXIT] key.
QUICK SET
TIME
TC SET
FILE SEL
DRV,PAT.
LIGHT
CONTRAST
EXIT
BATT
6. [LIGHT / CONTRAST] key
This key has primary (unSHIFTed) and secondary (SHIFTed) functions.
• When unSHIFTed:
Turns on or off the backlight of the display (see page 30).
Pressing this key turns on the backlight of the display, which is
automatically turned off after three seconds. If you keep holding down
this key for more than three seconds, the backlight keeps on lighting
until you press this key again.
• When SHIFTed:
By pressing this key, you can bring up the screen for adjusting the
display contrast using the [MENU] dial (see page 30).
After adjusting the contrast, pressing the [ENTER/YES] key confirms the
setting.
5. [FILE SEL / DRV, PAT] key
This key has primary (unSHIFTed) and secondary (SHIFTed) functions.
• When unSHIFTed:
Brings up the screen for selecting an audio file from the files recorded on
the current disk (or a hard disk partition) (see page 99). You can select a
file by highlighting the desired file using the [MENU] dial and pressing
the [ENTER/YES] key.
• When SHIFTed:
Brings up the screen for selecting the active drive for recording/play
back (see page 87). To exit the mode, press the [EXIT] key.
4. [TIME / TC SET] key
This key has primary (unSHIFTed) and secondary (SHIFTed) functions.
• When unSHIFTed:
Selects the time display mode on the display from ABS, LTC, TC IN and
GEN (see page 56).
• When SHIFTed:
Brings up the TC SETUP menu screen, on which you can make the
necessary settings for recording and playing back time code (see page
180). To exit the TC SETUP menu, press the [EXIT] key.
7. [EXIT / BATT] key
Used to cancel an edit operation or execution, as well as used to exit the
SETUP or UTILITY mode.
While the Home screen is shown, pressing and holding down this key
switches the screen to show the battery remaining condition instead of
the stereo bus bar-graph meters (see page 26).