Digital Multitracker Owner's Manual VF08
Table Of Contents
- SAFETY INSTRUCTIONS
- Contents
- Basic Features of VF08
- Names and Functions
- About the hard disk storage device
- Basic Recording and Playback
- Mixer Functions
- Recorder Functions
- Advanced Operation
- Save/Load of song data
- SETUP mode
- To enter the SETUP mode
- Time signature setting
- Setting a tempo
- Setting the Metronome function
- Setting MIDI sync output signal
- Setting an MTC frame rate
- Setting an MTC offset value
- Setting MTC Offset mode
- Setting the Slave mode
- Setting the Slave Type
- Setting the Record Protect function
- Setting Digital Input
- Setting BAR/BEAT Resolution mode
- Setting the MIDI device number
- Checking the number of track events
- The Drive Format Information
- Drive Setting
- Fader Fix Mode Setting
- Fader Recall Mode Setting
- Others
21
About the hard disk storage device
<Normal Screen>
Formatting the Hard disk
Carefully follow the instructions below to newly format the hard
disk properly.
Press the [ENTER/YES] key.
The drive selection display appears.
“IDE” will be flashed.
Press the [ENTER/YES] key where the “IDE” is flashed.
The menu to select the format type appears.
“****” represents the name of the drive.
<CAUTION>
Either the “Standard” or “Quick” format type can
be selected. However, make sure that the
“Standard”
format type is selected when
formatting a newly installed hard disk.
Press the [ENTER/YES] key where the “Standard” is
flashed.
The format type selected is set and “Sure?” flashes.
Press the [ENTER/YES] key while the [RECORD] key
is depressed.
The formatting process is started. The formatting
process will take some time.
When the formatting is successfully completed,
“Completed!” will light up on the display.
Press the [EXIT/NO] key (or [STOP] key) to escape from
the SETUP mode.
The Normal Screen appears indicating the beginning
of the program (P01) that is automatically created after
formatting the hard disk.
Flashing
Flashing
Flashing
1
Turn ON the VF08 after plugging the power cable in the
electric outlet.
The VF08 will startup. “Unformat!” will appear on the
LCD. The menu will automatically go to the SETUP
mode.
The display showing the “Disk Format” menu appears.
2
3
4
5
6