Digital Multitracker Owner's Manual VF08
Table Of Contents
- SAFETY INSTRUCTIONS
- Contents
- Basic Features of VF08
- Names and Functions
- About the hard disk storage device
- Basic Recording and Playback
- Mixer Functions
- Recorder Functions
- Advanced Operation
- Save/Load of song data
- SETUP mode
- To enter the SETUP mode
- Time signature setting
- Setting a tempo
- Setting the Metronome function
- Setting MIDI sync output signal
- Setting an MTC frame rate
- Setting an MTC offset value
- Setting MTC Offset mode
- Setting the Slave mode
- Setting the Slave Type
- Setting the Record Protect function
- Setting Digital Input
- Setting BAR/BEAT Resolution mode
- Setting the MIDI device number
- Checking the number of track events
- The Drive Format Information
- Drive Setting
- Fader Fix Mode Setting
- Fader Recall Mode Setting
- Others
29
Basic Recording/Playback
1
2
[ I] key
[I
] key
1
2
3
Mark function
The VF08 has the Mark function which allows you to set marks at the desired positions in a song.
You can locate a mark position immediately, as well as use mark positions for the punch in and out points, beginning
and end points for repeat and editing points for track editing such as copy, move, erase, etc.
This section describes how to set, delete and locate a mark. For details about editing a mark, see “Recorder func-
tions” described later.
Setting a mark on the fly
In the initial condition, Mark 00 is automatically en-
tered at the beginning of the current program (ABS
0) and named “ABS 0”.
You can enter up to 99 marks (Mark 01 through 99).
Mark number and name are shown on the Normal
screen as the arrow points in the screen example be-
low. (You cannot edit or delete Mark 00.)
During playback (or while stopped), press [|<< /
MARK]
key while holding down the [SHIFT] key.
“Entry Mark” is shown briefly and a mark is entered at
the current position.
Also the time marked is entered in the mark map list
(see “Recorder functions” for details).
To enter another mark, repeat step 1) above.
<Note>
Marks are assigned in ascending order of ABS time.
For example, even if you enter marks in order as shown
in the upper diagram below, the mark numbers are as-
signed as shown in the lower diagram.
Locating a mark
• Pressing [|<<] key locates the previous mark.
In the example above, each time you press the key from
the current position, the recorder will locate Mark 03 ->
02 -> 01 -> 00.
• Pressing [>>|] key locates the next mark.
In the example above, each time you press the key from
the current position, the recorder will locate Mark 04 ->
05 -> 06.
The current (located) mark number is shown on the
Normal screen.
Deleting a mark
You can delete unnecessary mark
While stopped, locate the mark to be deleted using the
[|<<] or [>>|] key.
The mark to be deleted is shown on the screen.
Press the [>>|/DELETE] key while holding down the
[SHIFT] key.
A pop-up panel asking for confirmation to delete the
current mark appears, in which “Sure?” blinks.
To cancel the operation for deletion, press the [EXIT/
NO] key.
Press the [ENTER/YES] key while holding down the
[RECORD] key.
The current mark is deleted.
You can locate a mark using the [|<<] or [>>|] key.
Current position