Digital Multitracker Owner's Manual VF08
Table Of Contents
- SAFETY INSTRUCTIONS
- Contents
- Basic Features of VF08
- Names and Functions
- About the hard disk storage device
- Basic Recording and Playback
- Mixer Functions
- Recorder Functions
- Advanced Operation
- Save/Load of song data
- SETUP mode
- To enter the SETUP mode
- Time signature setting
- Setting a tempo
- Setting the Metronome function
- Setting MIDI sync output signal
- Setting an MTC frame rate
- Setting an MTC offset value
- Setting MTC Offset mode
- Setting the Slave mode
- Setting the Slave Type
- Setting the Record Protect function
- Setting Digital Input
- Setting BAR/BEAT Resolution mode
- Setting the MIDI device number
- Checking the number of track events
- The Drive Format Information
- Drive Setting
- Fader Fix Mode Setting
- Fader Recall Mode Setting
- Others
88
Save/Load of Song data
After selecting the program, press the [ENTER/YES]
key.
The display shows the difference screens depending
on whether or not the program can be saved to a single
disk, as below.
•When the program can be saved to a single disk:
The display shows the screens for creating a new
program on the backup disk (the program number
"B01" is shown for the backup disk) and "Sure?" blinks.
Pressing the [ENTER/YES] key in the above condition
starts saving and the screens shown below appears.
<Hint>
While "B01: New PGM" is blinking, you can select
"Eject" for the forced eject by using the [JOG] dial.
When you remove the disk forcibly, select "Eject"
and press the [ENTER/YES] key. The disk will be
ejected and "Insert Disk" will blink on the display.
The screen above shows that the VF08 is saving the
song data of program 01 to B01 on the backup disk.
The remaining data size shown on the screen counts
down while the data save goes on. Wait for a while
until the save operation is completed.
When the save operation is completed, the display
changes to something like the one as shown below,
while the VF08 stops.
Blinking
Blinking
6
• When the program requires more than one disk for
saving:
Pressing the [ENTER/YES] key immediately starts
saving to the first disk and the "Data Saving" screen,
same as described above, appears.
The first disk is ejected when it becomes full, and
"Insert Disk2!" blinks on the screen.
Inserting the second disk to the SCSI device
automatically resumes saving.
If more than two disks are required for saving, repeat
the same procedure as above.
When the save operation to all disks is completed,
"Completed!" appears on the display, while the VF08
stops.
<Note>
You cannot abort the save operation before
completed, unlike the save operation using the S/
PDIF signal. Especially during the save operation
to more than one disk, if you happen to press the
[EXIT/NO] key while removing or inserting a disk,
you have to redo the save operation from the
beginning using the first disk.
Press the [EXIT/NO] key (or the [STOP] key)
repeatedly until exiting the setup mode.
• To remove the disk from the SCSI drive after the save
operation is completed, press the eject key on the SCSI drive.
7