R User Manual R www.aputure.
Foreword Thank you for purchasing Aputure Trigmaster Plus 2.4G. It inherits the advantages of previous flash and shutter trigger products while integrating exciting new features, bringing you a remarkable flash control experience. Read this instruction manual to better understand your new Trigmaster Plus 2.4G and maximize your shooting experience. Also refer to your camera and flash manual before use. Product Introduction Trigmaster Plus 2.
Battery Setup Components 1 2 3 4 5 7 8 12 Trigmaster Plus 2.4G uses two AAA 1.5V batteries, which can normally be used up to 100 hours. To insert the battery, open the battery hatch by following the arrow's direction; then insert the battery according to the +/icons, then close the battery hatch. 14 9 6 10 11 16 15 18 17 Body 1. Antenna 2. Status indicator lamp 3. Trigger button 4. Channel indicator lamp 5. Channel switch 6. Hot shoe connection 7. Function switch 8. Studio flash sync hole 9.
Operation Flash Trigger Operation Camera Remote Operation Triggering Use two (or more) Trigmaster Plus 2.4G units. One works as flash trigger (function switch set to TX/RX), connected to camera via Hot-shoe or PC cable; the other one works as flash receiver (function switch set to RX), connected to flash via Sync cable or Hot-shoe. Wired Mode Shutter Use one Trigmaster Plus 2.4G (function switch set to TX/RX), connected with camera via remote cable.
Interlink Triggering Operation Multiple Camera Shutter Control User can remotely trigger a flash in sync with camera to enable the whole system to work simultaneously. This is called relay mode. With Trigmaster Plus 2.4G, you can control multiple cameras at the same time. Place one unit on your master camera, and set it to TX/RX mode. Set the other units on your additional cameras, and set them to RX mode (Don't forget to attach the remote shutter cable).
Remote Test (Tested by two Trigmaster Plus 2.4G) One Trigmaster Plus 2.4G held in hand(function switch set to TX/RX), the other one connected with flash (function switch set to RX). Half-press the trigger button first, then press the channel switch, and the connected flash will be triggered and flash at the same time. Tips: To avoid channel changing, make sure to half-press the trigger button before pressing the channel switch, and release the trigger button after releasing the channel switch.
