MSDS

ManualsBrandsFoundation Armor ManualsPaintEpoxy 2-gal. Water-Based Clear High Gloss 2-Part Epoxy Primer and Top Coat for Concrete Floors

Page 1 of 5

FOUNDATION ARMOR

3 Bud Way STE 27 DATE ISSUED 12/10/2014 24 HOUR EMERGENCY PHONE

Nashua, NH 03063 DATE REVISED 12/10/2014 800-424-9300

Phone: 866-306-0246

MATERIAL SAFETY DATA SHEET

SECTION I / IDENTIFICATION OF MATERIAL

PRODUCT NAME

Armor Epoxy Part A

USE

Component for concrete

coating

CHEMICAL FAMILY

N/A

SECTION II / HAZARDOUS INGREDIENTS

COMPONENT

CAS #

TVL(ACGIH)

PEL(OSHA)

Oxirane, 2,2’-[(1-methylethylidene)bis(4,1-

Phenyleneoxymethylene)]bis-homopolymer

25085-99-8

N/A

SECTION III / PHYSICAL DATA

APPEARANCE & ODOR

White liquid with low odor

MELTING POINT (C)

N/A

BOILING POINT

212 F (100 C)

DENSITY

69.295 lb.ft3 (1.11

g/cm3) at 70 F (21 C)

SPECIFIC GRAVITY

1.09

% WATER

40-60

% VOC

< 20 grams/liter

VAPOR PRESSURE (mm Hg)

19.30 mmHg @ 70 F

(21 C)

VISCOSITY

N/A

SOLUBILITY IN WATER

Soluble

Neutral

SECTION IV / FIRE AND EXPLOSION HAZARD DATA

FLASHPOINT

> 248.89 C

METHOD

N/A

FLAMMABLE LIMITS

LEL

N/A

UEL

N/A

SUITABLE EXTINGUISHING

MEDIA

Alcohol-resistant foam. Carbon dioxide (CO2). Dry Chemical. Dry Sand.

Limestone powder.

SPECIAL FIREFIGHTING

PROCEDURES

Use personal protective equipment. Wear self contained breathing apparatus for

fire fighting if necessary.

UNUSUAL FIRE AND EXPLOSION

HAZARDS

N/A

SECTION V / REACTIVITY DATA

STABILITY (CHECK ONE)

UNSTABLE

STABLE

CONDITIONS TO AVOID

N/A

INCOMPATABILITY

N/A

HAZARDOUS DECOMPOSITION

PRODUCTS

Summary of content (5 pages)

PAGE 1
Page 1 of 5 FOUNDATION ARMOR 3 Bud Way STE 27 Nashua, NH 03063 Phone: 866-306-0246 DATE ISSUED DATE REVISED 12/10/2014 12/10/2014 24 HOUR EMERGENCY PHONE 800-424-9300 MATERIAL SAFETY DATA SHEET SECTION I / IDENTIFICATION OF MATERIAL PRODUCT NAME Armor Epoxy Part A USE Component for concrete coating CHEMICAL FAMILY N/A SECTION II / HAZARDOUS INGREDIENTS COMPONENT CAS # Oxirane, 2,2’-[(1-methylethylidene)bis(4,1Phenyleneoxymethylene)]bis-homopolymer 25085-99-8 % TVL(ACGIH) N/A PEL(OSHA) N/
PAGE 2
Page 2 of 5 SECTION VI / HEALTH HAZARD DATA INHALATION Irritation and cracking of skin in severe cases. Clean with soap and water. Seek medical attention if symptoms persist. Will cause irritation. Flush with water for 15 minutes. Seek medical attention if problem persists. May cause dizziness and light headiness. Remove to fresh air. INGESTION Seek medical attention.
PAGE 3
Page 3 of 5 FOUNDATION ARMOR 3 Bud Way STE 27 Nashua, NH 03063 Phone: 866-306-0246 DATE ISSUED DATE REVISED 12/10/2014 12/10/2014 24 HOUR EMERGENCY PHONE 800-424-9300 MATERIAL SAFETY DATA SHEET SECTION I / IDENTIFICATION OF MATERIAL PRODUCT NAME Armor Epoxy Part B USE Component for concrete coating CHEMICAL FAMILY N/A SECTION II / HAZARDOUS INGREDIENTS COMPONENT CAS # Poly(oxy(methyl-1,2-ethanedyl), alpha-(2aminomethylethyl)-omega-(2aminomethylethoxy) 9046-10-0 % TLV(ACGIH) N/A N/A N/A
PAGE 4
Page 4 of 5 CONDITIONS OR MATERIALS TO AVOID N/A SECTION VI / HEALTH HAZARD DATA INHALATION Irritation and cracking of skin in severe cases. Clean with soap and water. Seek medical attention if symptoms persist. Will cause irritation. Flush with water for 15 minutes. Seek medical attention if problem persists. May cause dizziness and light headiness. Remove to fresh air. INGESTION Seek medical attention.
PAGE 5
Page 5 of 5 THIS DOCUMENT HAS BEEN PREPARED USING DATA FROM SOURCES CONSIDERED TECHNICALLY RELIABLE. THERE ARE NO GUARANTEES TO ITS ACCURACY OR SUITABILITY TO SPECIFIC APPLICATIONS. ACTUAL CONDITIONS OF USE, HANDLING, AND END PRODUCT PERFORMANCE ARE THE SOLE RESPONSIBILITY OF THE USER. THE USER ASSUMES ALL RISK AND LIABILITY FOR USE BEYOND FOUNDATION ARMOR CONTROL INCLUDING COMPLIANCE WITH LOCAL, STATE AND FEDERAL REGULATIONS.