Assembly Instructions

ManualsBrandsFoundstone ManualsFurnitureKinsey 52'' Wide 2 Drawer Buffet Table

Table Of Contents

P.1

Summary of content (34 pages)

PAGE 2
General Assembly Guidelines . Ensure that all parts and hardware are available before beginning assembly. . Follow each step carefully to ensure the proper assembly of this product. . Two people are recommended for ease in the assembly of this product. V. V. The three main types of hardware used to assemble this product are : wood dowels , screws and bolts. The provided glue is to secure wood dowels in place .
PAGE 4
Hardware List A Ø8x30mm Wooden dowel 18 pcs B Ø6x35mm Cam bolt 18 pcs C Ø15x11mm Cam lock 10 pcs D Ø15x9mm Cam lock 8 pcs Sticker 18 pcs E F Ø6x50mm Screw 8 pcs G Ø6x12mm Bolt 20 pcs H M4 Hex Key 1 pc J L shape shelf support pin 8 pcs K Shelf support pin 4 pcs L Handle 3 pcs M Europe hinge 2 pcs N Ø3.
PAGE 5
Hardware List X Y Ø3x12mm Screw 30 pcs Drawer slider 2 sets *Note: This piece comes preassembled for shipping purposes and must be disassembled to complete the desk assembly. Philips head screwdriver required for assembly (not included) The hardware quantities listed above are required for proper assembly. Some extra hardware may also have been included. All rights reserved. P.
PAGE 12
Step 7 B 15 B B B L B X 19 B B B L X Secure cam bolt (B) into parts (15,19) ,then using screw (X) attach handle (L) to parts (15,19) with Philips head screwdriver as per diagram. All rights reserved. P.
PAGE 27
Step 22 OR Slider arm Y Slider bracket 15 19 Assembled the drawers as per diagram Note :If the drawer does not go in smoothly .Press or lift the plastic release lever . Pull out the slider bracket from the slider arm then re-assembled the drawer until they were going in smoothly well . All rights reserved. P.
PAGE 28
Step 23 6 J K 3 4 J J 10 K K 8 10 Finished edge 8 J K K Insert shelf support pin (K) into parts (3,4) ,L shape shelf support pin (J) into parts (4,6) as per diagram. Make sure you place the four shelf support pins in the same level. So the shelf is not titled .Put parts (8,10) into unit as per diagram. Tilt and rest the adjustable shelf(8,10) onto the shelf support pins . All rights reserved. P.
PAGE 30
Step 25 3 9 N N M N N Using screw (N) attach Europe hinge (M) into part (3) with Philips head screwdriver as per diagram. Close and open the door .If necessary ,adjust the screws for a good fit . All rights reserved. P.
PAGE 33
1 Step 28 2 3 WARNING Serious or fatal injuries can occur from furniture tipping over. To prevent the furniture from tipping over we recommend that it is permanently fixed to the wall. Wall anchor and hardware are included with this product. Please make sure hardware is suitable for your walls before installing, as different wall materials may require different types of anchors. Wall V T U (EN) Using screw (T) attach plastic strap (U) into nut (V) to wall with Philips head screwdriver as per diagram.