Installation Guide

page 7
7. Canopy Assembly.
8. Blade Assembly.
Remove blade screws/lock washers from
underside of motor. Align blade holes with
motor screw holes and attach blade with
screws/lock washers. Repeat this procedure
with remaining blades. Secure all
screws/lock washers.
Note: Tighten blade screws twice a year.
canopy
hanging
bracket
screw
screw
motor
housing
blade
blade screw/lock washer
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both
screws securely.