Installation Instructions

INSTALLATION INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Page: 1/2
Fig. 1
Fig. 3
PREPARATION (Fig. 1)
1.
Shut off the power at the fuse box or circuit breaker. If
necessary, remove the old fixture, including the mounting
hardware.
2. Carefully remove the fixture from the carton and check that
all parts are included as shown in the illustration.
ASSEMBLING THE FIXTURE WITH BALL SWIVEL (Fig. 2)
3. Determine the desired hanging height and thread rods (F1,
4. Attach the mounting plate (A) to the junction box using
mounting screws (B) (Size: #8-32N*L0.5”).
5. Place the canopy (C) over rods (F) and thread the hanger
ball (E) to rods (F). Please remove the nipple if installing
with one 6” rod only.
6. Install the fixture body into the mounting plate (A) by tilting
at a slight angle so that the hanger ball (E) slips into
the
mounting plate (A) as shown. Align the notch in the hanger
ball (E) to the tab on the mounting plate (A) to prevent the
fixture from turning.
CONNECTING THE WIRES (Fig. 3)
7. At this
point, connect the electrical wires as shown in figure
3, making sure that all wire connectors are secured.
If your
outlet has a ground wire (green or bare copper), connect
the ground wires from the hanger ball and mounting plate
to it. Otherwise, connect the ground wire from the hanger
ball directly to the mounting plate ground wire and
secure
with the wire connectors provided. After wires are
connected, tuck them carefully into the ceiling junction box.
COMPLETING THE INSTALLATION (Fig. 1)
8. Align the canopy (C) over the mounting plate (A)
and
secure with screws (D).
9. Install the light bulb(s) (not included)
in accordance with the
fixture’s specifications.
(DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!) (
NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!).
.
Your
installation is now complete. Return power to the junction
box and test the fixture.
Note:
Illustration (Fig. 1) on this manual is for installation
purposes only. It may or may not be identical to the fixture
purchased.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
F
IXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
READ AND SAVE THESE INSTRUCTIONS
Set
- Mounting plate
- Ground screw
- Mounting Screw*2
F2 and F3) to the nipple of the fixture body (G). Pass the
wires carefully through each rod as you assemble.
Rod
1(F1)
2(F2)
1(F3)