Installation Instructions

877-369-2562 | WWW.FOXBLOCKS.COM | 6110 Abbott Drive | Omaha, NE 68110
Fox Blocks ICF Guidebook V5MAR17
18
Fox Blocks Products & Accessories
FOX BLOCKS REVEAL
PRODUCT
When exposed concrete is needed
on one or two faces.
The Fox Blocks Reveal product is an innovative one-sided form. The one-sided
Reveal form provides the standard 2 5/8" thick expanded polystyrene (EPS) foam on
one side of the concrete wall and temporary wood forming on the other side of the wall.
The temporary wood form is then removed after the concrete is placed and cured.
The net result is insulation on one side of the Fox Blocks wall and bare concrete on
the opposite side. The Fox Blocks one-sided form can become a valuable and
efficient tool for use on the following applications.
• Elevator wall shafts
• Stairwell walls
• Gymnasiums
• Certain floor line details
The Fox Blocks Reveal is shipped to the jobsite ready to stack with the temporary wood
form fastened to the plastic tie insert furring strips on the non-insulated side of the wall.
Fox Blocks provides the complete one-sided product to the jobsite ready to stack. No
need to purchase your own panels or jigs for assembly. Each Reveal form is 48 inches
long and 16 inches high. The concrete wall will actually be 2 5/8" thicker than the
standard Fox Blocks wall as the 2 5/8” thick EPS foam is replaced with concrete. For
example, the 6 inch Reveal form will provide 8 5/8" thick concrete.
The form is stacked normally like the other Fox Blocks forms. After the concrete is
placed and cured, the temporary wood form is removed. At each location on the
exposed concrete side of the wall where the wood form was fastened, there will be a
small cavity left in the concrete. This cavity is grouted the same way as a snap tie cavity
is grouted with conventional concrete walls.
GO TO FOXBLOCKS.COM FOR UPDATED INFORMATION