User Guide

Step and Feed value
E.g.: Step value=10 means moving
distance is 10mm. Feed value=2000
means 2000mm/min
Spindle ON/OFF. Because it is
manual speed control, the
software can only control the
spindle on/off, and cannot
perform software speed control,
so the progress bar does not work
Open G-code file
3D preview interface,
hold the
left mouse button, can
rotate
Angle, scroll the mouse
wheel, can be enlarged,
or reduced.
If you cannot see
anything, you need to
change to a computer
with support for
OpenGL2.0 graphics cards.
Send G-code file
Coordinate display
Status display
Common operation button, the mouse
icon on the above shows the specific
function
Command input box
Send command
Manual operation Direction buttons
Grblcontrol (Candle) Working Interface Introduction
Pattern size
-25-