User Manual

Product Specifications& Instruction

Spindle Specification

Model DC 300W

Rotating speed 10000 RPM

Torque 400mN.m

Input Current 6A

Power 300W

Input Voltage DC 12-48V

Accuracy 0.01mm

Insulation Resistance >2 Megohm

Insulation Dielectric Strength 400V

Wiring Diagram

0-48V DC Output

GND

VCC

This switch should be set to the

left side when using 300W spindle.

It should be set to the right side

when using 60W spindle or laser

module.

12V5A DC Input

PAGE 1
Product Specifications& Instruction Spindle Specification Model DC 300W Rotating speed 10000 RPM Torque 400mN.m Input Current 6A Power 300W Input Voltage DC 12-48V Accuracy 0.01mm Insulation Resistance >2 Megohm Insulation Dielectric Strength 400V Wiring Diagram 0-48V DC Output This switch should be set to the left side when using 300W spindle. It should be set to the right side when using 60W spindle or laser module.
PAGE 2
Use Attentions • The power box comes with this upgrade kit is used to power the 300W spindle. The control board still needs the original power supply to power (12V 5A). • The control board controls the spindle via the relay. • The black switch on the control board should be set to the left side when using 300W spindle (see diagram). Remove the 60W spindle/laser wire from the control board when you use 300W spindle. • The switch should be set to the right side when using 60W spindle or laser module.