Owner's Manual

SuperIO Devices

► OnBoard FDC Controller

This item is used to enable or disable the onboard FDC controller.

► OnBoard Serial Port 1

This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial

port COM1.

► OnBoard Serial Port 2

This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial

port COM2.

► Serial Port 2 Mode Select

This item is used to congure COM2 PORT as :

[Normal] : A RS232 device.

[IrDA] : An IrDA device for maximum 115200 bit/s.

[ASKIR] : A faster IrDA for 1152000 bit/s.

► IrDA Duplex Mode

This item enables you to determine the transfer mode of the onboard infrared chip.

► OnBoard Parallel Port

This item is used to assign the I/O address and interrupt request (IRQ) for the onboard parallel

(or Printer) port.

► Parallel Port Mode

This item is used to select the operation modes for the onboard parallel (or Printer) port. They

are [SPP], [EPP], [ECP] and [ECP/EPP].

► ECP Mode Use DMA

When “Parallel Port Mode“ set to “ECP“ or “ECP+EPP “, this item is used to select the the

channel of ECP mode.

Phoenix - AwardBIOS CMOS Setup Utility

SuperIO Devices

OnBoard FDC Controller

[Enabled] Item Help

OnBoard Serial Port 1

[3F8/IRQ4]

OnBoard Serial Port 2

[2F8/IRQ3] Menu Level ►

Serial Port 2 Mode Select [Normal]

x IrDA Duplex Mode Half

OnBoard Parallel Port [378/IRQ7]

Parallel Port Mode [SPP]

ECP Mode Use DMA 3

↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help

F5: Previous Values F7: Optimized Defaults

Enabled