User's Manual

We strongly recommend high capacity NiMH rechargeable batteries over
alkaline types for maximum performance, particularly when using loud
volume levels.
1) Remove the battery door. The battery door is located on the side of
the caller and is held in place with a knurled thumbscrew.
2) Orient the batteries as per the directions shown in each cavity within
the holder. Note that the battery polarity alternates.
3) Replace the battery door after the batteries are installed.
1.2 INSTALLING BATTERIES IN YOUR TX-500
The TX-500 transmitter operates from three AA batteries. Please use high
quality alkaline or lithium batteries.
1) Remove the battery compartment over located on the rear of the
transmitter.
2) Insert the AA batteries into the provided cavities. Note that the battery
polarity alternates.
3) Replace the battery compartment cover after the batteries are installed.
1.3 PLAYING SOUNDS MANUALLY
Your Fury can be operated with or without using the TX-500 transmitter. There
may be times when you want the sound of the unit right next to you or perhaps
you want to walk with the unit to create a travelling sound.
1) Make sure that at least one of the speaker selector slide switches is set
to the right, or “ON” position (see the following image).
2) Turn the On/Off/Volume knob clockwise to the “on” position – you
should hear a soft click. Please note that this switch is also the volume
control when the unit is operated without the remote control. The