User's Manual

volumes with the push of a button. The TX-500 can hold a total of ten individual
sound presets, each one having their own unique volume level. You will also
find two quick-access buttons (P1 and P2) that provide you one-button access
to the sounds stored on presets one and two.
Creating Presets
1) Press the PRESET button and hold for approximately 3-4 seconds to
enter set preset mode. You should see SEL SND/ VOL on the top line
of the TX-500 display.
2) Use volume up/down buttons to set the desired volume level
3) Select the desired sound by using the rotary selector knob to highlight
it on the screen and then press the selector knob down one time.
4) To lock the selected volume and sound in, press the desired number
(0-9) for that preset on the keypad. When pressing the number button,
this exits you from set preset mode and you are now in the preset
mode.
5) To add another preset, follow steps 1-5.
Playing a Preset
1) Briefly press the PRESET button one time to enter preset mode.
2) Press the desired number of the preset you wish to play. Make sure
that you have preset in place prior to attempting to play it. The chosen
preset should play immediately.
6.9 FOXFADE
FOXFADE allows you to fade the volume level of the sound being played
between the front and rear speaker and allows you shut them off. There are
three ways in which FOXFADE can be used; mono, stereo, and reversed
stereo. FOXFADE will provide the best effect when using a stereo audio file
that contains two separate animal recordings; however, it can be used with
mono sounds that are being played in stereo mode.
Using FOXFADE
1) With the sound playing, press the FOXFADE button on the side of the
TX-500 transmitter
2) Use the selector knob to move the cursor left or right on the screen.