User's Manual

being displayed upon incrementing to the next page. SINGLE will allow you
to increment up by one sound at a time rather than a page at a time.
NOTE: By default, the scroll option will be set to SINGLE.
Backlight
There are four options in the backlight menu; ALWAYS OFF, LOW,
MEDIUM, HIGH, and ALWAYS ON. To change the backlight settings, use
the selector to highlight the desired option then press down on the selector
knob one time.
NOTE: You should experiment with the different settings to find out
which ones work the best in varying conditions.
CHANNEL
You can select the desired channel that you want to TX-500 to operate on
from this menu. Make sure that the channel selected in the TX-500
corresponds to the same channel setup in the Prairie Blaster. See the
channel selection section for more information. To change the channel, use
the selector to highlight the desired option then press down on the selector
knob one time.
VOLUME STEPS
This menu allows you to customize the speed at which the TX-500 will ramp
the volume. The options are 2, 4, 5, 8, and 10. To change the volume step
settings use the selector to highlight the desired option then press down on
the selector knob one time.
NOTE: Experiment with the volume steps to find out which one
works the best for you. By default, the volume step will be set to 2.
UPLOAD SOUND LIST
After reprogramming your Prairie Blaster, this menu item will allow you to
upload the new sound list from the Prairie Blaster to your TX-500. For more
information read the programming section of this manual.
TIMER
The TX-500 transmitter features a timer displayed on the bottom status line.
This makes it handy for determining length of stands, and to determine
respond times of incoming animals. When your TX-500 is turned on, the
timer begins counting. The timer displays minutes and seconds up to 99:59.
Once this time is reached, the timer rolls over to 00:00, and commences