User's Manual
Table Of Contents
- One-Year Limited Warranty
- Safety Information
- Safety Message Conventions Used
- Important Safety Instructions
- 1 Using This Manual
- 2 Introduction
- 3 Getting Started
- 4 Vehicle Identification
- 5 Diagnosis
- 6 Maintenance
- 6.1 Oil Light Reset
- 6.2 Electronic Parking Brake (EPB) Service
- 6.3 Battery Replacement (BRT)
- 6.4 Diesel Particulate Filter (DPF) Regeneration
- 6.5 Throttle Body Alignment (TPS/TBA)
- 6.6 Steering Angle Sensor (SAS) Calibration
- 6.7 Continuous Variable Transmission (CVT)
- 6.8 Gear Learning
- 6.9 Tire Pressure Monitoring System Programming
- 6.10 Odometer
- 6.11 Injector Coding
- 6.12 ABS Bleeding
- 6.13 Key Programming/Immobilizer
- 7 Data Manager
- 8 VCI Manager
- 9 Registration and Update
- 10 Settings
- 11 Shop Manager
- 12 My Account
- 13 Remote Support
- 14 Technical Data
74
Premier Diagnostic Platform NT909 User's Manual V1.01
Figure 10-1 Sample Language Setting Screen
10.3 Push Message
This option allows you to enable/disable Push Message function. Software
updates and technical information will be delivered to you automatically. It is
highly recommended to enable it all the time, so you won’t miss out any new
updates from Foxwell.
To enable/disable Push Message:
1. Press Settings from home screen of the NT909 diagnostic application.
2. Click the button on the right side. If turned to green, the Push Message
function is enabled. If turned to grey, the function is disabled.
Figure 10-2 Sample Push Message Setting Screen
10.4 Automatic Update
This option allows you to enable/disable automatic update notice. If it is
enabled, an orange update mark will show on the upper right of the diagnostic
software icon whenever there is a new version available.