User's Manual
Table Of Contents
- One-Year Limited Warranty
- Safety Information
- 2 Introduction
- 3 Getting Started
- 4 Vehicle Identification
- 5 Diagnosis
- 6 Maintenance
- 6.1 Oil Light Reset
- 6.2 Electronic Parking Brake (EPB) Service
- 6.3 Battery Replacement (BRT)
- 6.4 Diesel Particulate Filter (DPF) Regeneration
- 6.5 Throttle Body Alignment (TPS/TBA)
- 6.6Steering Angle Sensor (SAS) Calibration
- 6.7Continuous Variable Transmission (CVT)
- 6.8Gear Learning
- 6.9 Tire Pressure Monitoring SystemProgramming
- 6.10Injector Coding
- 6.11ABS Bleeding
- 6.12Key Programming/Immobilizer
- 7 Data Manager
- 8.My Account
- 9 Update
- 10VCI Manager
- 11 Firmware Update
- 12 Settings
- 13 Remote Support
Automotive Diagnostic SystemI70BT User's Manual V1.0
11
Figure 2-2 Top View
3
Power Switch - turns on the scanner, goes to sleep mode or wake up
the scanner from sleep mode, press and hold for 3 seconds for
emergency shutdown.
4
USB Type-C Port - connects to wall plug to charge the scanner and can
be used for data transfer.
5
USB Port - provides a USB connection for the external storage devices,
oscilloscope or video scope etc.
IMPORTANT
Do not use solvents such as alcohol to clean display. Use a mild nonabrasive
detergent and a soft cotton cloth.
2.2 VCI Dongle Descriptions
NT809BT connects to the vehicle and get data through the VCI dongle either
by Bluetooth or USB communication.