User's Manual
Table Of Contents
- One-Year Limited Warranty
- Safety Information
- 2 Introduction
- 3 Getting Started
- 4 Vehicle Identification
- 5 Diagnosis
- 6 Maintenance
- 6.1 Oil Light Reset
- 6.2 Electronic Parking Brake (EPB) Service
- 6.3 Battery Replacement (BRT)
- 6.4 Diesel Particulate Filter (DPF) Regeneration
- 6.5 Throttle Body Alignment (TPS/TBA)
- 6.6Steering Angle Sensor (SAS) Calibration
- 6.7Continuous Variable Transmission (CVT)
- 6.8Gear Learning
- 6.9 Tire Pressure Monitoring SystemProgramming
- 6.10Injector Coding
- 6.11ABS Bleeding
- 6.12Key Programming/Immobilizer
- 7 Data Manager
- 8.My Account
- 9 Update
- 10VCI Manager
- 11 Firmware Update
- 12 Settings
- 13 Remote Support
Automotive Diagnostic SystemI70BT User's Manual V1.0
17
prompts and make a series of choices. Each selection you make advances
you to the next screen. Exact procedures may vary somewhat by vehicle.
It typically identifies a vehicle by any of the following means:
● VIN Reading
● Manual Selection
NOTE
Not all identification options listed above are applicable to all vehicles.
Available options may vary by vehicle manufacturer.
4.1Vehicle Connection
To establish communication with NT809BT:
1. Power up the tablet.
2. Connect the VCI dongle to the vehicle’s DLC for both communication and
power source. The working range for Bluetooth communication is about
10-20m, providing easy connection to vehicles in any location throughout the
shop.
Figure 4-1 Sample Communication Screen
.
3. The VCI dongle will connect to the tablet automatically.