User's Manual
Table Of Contents
- One-Year Limited Warranty
- Safety Information
- 2 Introduction
- 3 Getting Started
- 4 Vehicle Identification
- 5 Diagnosis
- 6 Maintenance
- 6.1 Oil Light Reset
- 6.2 Electronic Parking Brake (EPB) Service
- 6.3 Battery Replacement (BRT)
- 6.4 Diesel Particulate Filter (DPF) Regeneration
- 6.5 Throttle Body Alignment (TPS/TBA)
- 6.6Steering Angle Sensor (SAS) Calibration
- 6.7Continuous Variable Transmission (CVT)
- 6.8Gear Learning
- 6.9 Tire Pressure Monitoring SystemProgramming
- 6.10Injector Coding
- 6.11ABS Bleeding
- 6.12Key Programming/Immobilizer
- 7 Data Manager
- 8.My Account
- 9 Update
- 10VCI Manager
- 11 Firmware Update
- 12 Settings
- 13 Remote Support
Automotive Diagnostic SystemI70BT User's Manual V1.0
29
recorded by the on-board computer at the time of the DTC set. It is a good
function to help determine what caused the fault.
Figure 5-11 Sample Freeze Frame Screen
●
Help - select one fault code from the code list and click Help button on the
screen. The screen will display the detailed descriptions about the fault
code and repair guide.
Figure 5-12 Sample DTC Help Screen
2. Slide up and down to view additional information when necessary.
3. Press Save to store DTC information.Press to print the information if
need be. Press to exit.
5.2.2Clear Codes
Clear Codes menu lets you to clear all current and stored DTCs from a
selected control module. Also it erases all temporary ECU information,
including freeze frame, so make sure that the selected system is completely
checked and serviced by technicians and no vital information will be lost
before clearing codes.
NOTE
● To clear codes, make sure that the ignition key is switched to ON with the
engine off.