User's Manual
Table Of Contents
- One-Year Limited Warranty
- Safety Information
- 2 Introduction
- 3 Getting Started
- 4 Vehicle Identification
- 5 Diagnosis
- 6 Maintenance
- 6.1 Oil Light Reset
- 6.2 Electronic Parking Brake (EPB) Service
- 6.3 Battery Replacement (BRT)
- 6.4 Diesel Particulate Filter (DPF) Regeneration
- 6.5 Throttle Body Alignment (TPS/TBA)
- 6.6Steering Angle Sensor (SAS) Calibration
- 6.7Continuous Variable Transmission (CVT)
- 6.8Gear Learning
- 6.9 Tire Pressure Monitoring SystemProgramming
- 6.10Injector Coding
- 6.11ABS Bleeding
- 6.12Key Programming/Immobilizer
- 7 Data Manager
- 8.My Account
- 9 Update
- 10VCI Manager
- 11 Firmware Update
- 12 Settings
- 13 Remote Support
Automotive Diagnostic SystemI70BT User's Manual V1.0
30
●
Clear Codes does not fix the problem that caused the fault! DTCs should
only be erased after correcting the condition(s) that caused them.
To clear codes:
1. Press Clear Codes from Select Diagnostic Function menu.
Figure 5-13 Sample Function Menu Screen
2. Follow the on-screen instructions and answer questions about the vehicle
being tested to complete the procedure.
3. Check the codes again. If any codes remain, repeat the Clear Codes
steps.
5.2.3Live Data
Live Data menu lets you view real time PID data in text and plot formats,
learn good sensor data and compare them with faulty data, and record live
data from a selected vehicle electronic control module.
There are two ways to select the PID data of control module:
● All Data
● Custom List
Figure 5-14 Sample Function Menu Screen
5.2.3.1 All Data
All Data menu lets you view all live PID data from a selected control module.