User's Manual
Table Of Contents
- One-Year Limited Warranty
- Safety Information
- 2 Introduction
- 3 Getting Started
- 4 Vehicle Identification
- 5 Diagnosis
- 6 Maintenance
- 6.1 Oil Light Reset
- 6.2 Electronic Parking Brake (EPB) Service
- 6.3 Battery Replacement (BRT)
- 6.4 Diesel Particulate Filter (DPF) Regeneration
- 6.5 Throttle Body Alignment (TPS/TBA)
- 6.6Steering Angle Sensor (SAS) Calibration
- 6.7Continuous Variable Transmission (CVT)
- 6.8Gear Learning
- 6.9 Tire Pressure Monitoring SystemProgramming
- 6.10Injector Coding
- 6.11ABS Bleeding
- 6.12Key Programming/Immobilizer
- 7 Data Manager
- 8.My Account
- 9 Update
- 10VCI Manager
- 11 Firmware Update
- 12 Settings
- 13 Remote Support
Automotive Diagnostic SystemI70BT User's Manual V1.0
6
such as in below-ground pits, confined areas, or areas that are less than
18 inches (45 cm) above the floor.
● Do not smoke, strike a match, or cause a spark near the vehicle while
testing and keep all sparks, heated items and open flames away from the
battery and fuel / fuel vapors as they are highly flammable.
● Keep a dry chemical fire extinguisher suitable for gasoline, chemical and
electrical fires in work area.
● Always be aware of rotating parts that move at high speed when an engine
is running and keep a safe distance from these parts as well as other
potentially moving objects to avoid serious injury.
● Do not touch engine components that get very hot when an engine is
running to avoid severe burns.
● Block drive wheels before testing with engine running. Put the transmission
in park (for automatic transmission) or neutral (for manual transmission).
And never leave a running engine unattended.
● Do not wear jewelry or loose fitting clothing when working on engine.