User Manual
Table Of Contents
- One-Year Limited Warranty
- Safety Information
- 1 Using This Manual
- 2 Introduction
- 3 Getting Started
- 4 Vehicle Identification
- 5 Diagnosis
- 6 Maintenance
- 6.1 Oil Light Reset
- 6.2 Electronic Parking Brake (EPB) Service
- 6.3 Battery Replacement (BRT)
- 6.4 Diesel Particulate Filter (DPF) Regeneration
- 6.5 Throttle Body Alignment (TPS/TBA)
- 6.6 Steering Angle Sensor (SAS) Calibration
- 6.7 Continuous Variable Transmission (CVT)
- 6.8 Gear Learning
- 6.9 Tire Pressure Monitoring System Programming
- 6.10 Odometer
- 6.11 Injector Coding
- 7 Data Manager
- 8 Firmware Update
- 9 Registration and Update
- 10 Settings
- 11 Shop Manager
- 12 My Account
- 13 Remote Support
- 14 Technical Data
12
Next Generation Diagnostic Platform GT60 User's Manual V1.01
Figure 2-2 Top View
3
Diagnostic Port -provides connection between vehicle and the scanner.
4
USB Type-C Port - connects to wall plug to charge the scanner and can
be used for data transfer.
5
USB Port - provides a USB connection for the external storage devices,
oscilloscope or video scope etc.
6
Power Switch - turns on the scanner, goes to sleep mode or wake up
the scanner from sleep mode, press and hold for 3 seconds for
emergency shutdown.
Figure 2-3 Back View
7
Rear-Facing Camera - takes pictures of VIN number, faulty parts and
plates and shoots test videos.
IMPORTANT
Do not use solvents such as alcohol to clean display. Use a mild nonabrasive
detergent and a soft cotton cloth.