User Manual

46
Next Generation Diagnostic Platform GT60 User's Manual V1.01
6.8 Gear Learning
The crankshaft position sensor learns crankshaft tooth machining tolerance
and save to the computer to more accurately diagnose engine misfires. If
tooth learning is not performed for a car equipped with Delphi engine, the MIL
turns on after the engine is started. The diagnostic device detects the DTC P
1336 'tooth not learned'. In this case, you must the diagnostic device to
perform tooth learning for the car. After tooth learning is successful, the MIL
turns off.
After the engine ECU, crankshaft position sensor, or crankshaft flywheel is
replaced, or the DTC 'tooth not learned' is present, tooth learning must be
performed.
6.9 Tire Pressure Monitoring System Programming
TPMS Service menu allows you to check the tire sensor IDs from the vehicle
ECU and to perform TPMS programming and reset after tires and/or TPM
sensors are replaced and/or tires are rotated.
6.10 Odometer
This function allows you to revise the date of odometer and write the original
date into new odometer.
6.11 Injector Coding
Write injector actual code or rewrite code in the ECU to the injector code of the
corresponding cylinder so as to more accurately control or correct cylinder
injection quantity. After the ECU or injector is replaced, injector code of each
cylinder must be confirmed or re-coded so that the cylinder can better identify
injectors to accurately control fuel injection.
7 Data Manager
Data Manager menu let you review stored screenshots and test reports,
playback recorded live data and other saved files.
Typical menu options include:
●
Image
● PDF
● Data Playback
● Data Record