User Manual
Table Of Contents
- One-Year Limited Warranty
 - Safety Information
 - 1 Using This Manual
 - 2 Introduction
 - 3 Getting Started
 - 4 Vehicle Identification
 - 5 Diagnosis
 - 6 Maintenance
- 6.1 Oil Light Reset
 - 6.2 Electronic Parking Brake (EPB) Service
 - 6.3 Battery Replacement (BRT)
 - 6.4 Diesel Particulate Filter (DPF) Regeneration
 - 6.5 Throttle Body Alignment (TPS/TBA)
 - 6.6 Steering Angle Sensor (SAS) Calibration
 - 6.7 Continuous Variable Transmission (CVT)
 - 6.8 Gear Learning
 - 6.9 Tire Pressure Monitoring System Programming
 - 6.10 Odometer
 - 6.11 Injector Coding
 
 - 7 Data Manager
 - 8 Firmware Update
 - 9 Registration and Update
 - 10 Settings
 - 11 Shop Manager
 - 12 My Account
 - 13 Remote Support
 - 14 Technical Data
 
6
Next Generation Diagnostic Platform GT60 User's Manual V1.01
such as in below-ground pits, confined areas, or areas that are less than
18 inches (45 cm) above the floor.
● Do not smoke, strike a match, or cause a spark near the vehicle while
testing and keep all sparks, heated items and open flames away from the
battery and fuel / fuel vapors as they are highly flammable.
● Keep a dry chemical fire extinguisher suitable for gasoline, chemical and
electrical fires in work area.
● Always be aware of rotating parts that move at high speed when an engine
is running and keep a safe distance from these parts as well as other
potentially moving objects to avoid serious injury.
● Do not touch engine components that get very hot when an engine is
running to avoid severe burns.
● Block drive wheels before testing with engine running. Put the transmission
in park (for automatic transmission) or neutral (for manual transmission).
And never leave a running engine unattended.
● Do not wear jewelry or loose fitting clothing when working on engine.
● Don't connect or disconnect the equipments while the ignition is on or the
engine is running.










