User's Manual
Table Of Contents
- One-Year Limited Warranty
- Safety Information
- Safety Message Conventions Used
- Important Safety Instructions
- 1 Using This Manual
- 2 Introduction
- 3 Getting Started
- 4 Vehicle Identification
- 5 Diagnosis
- 6 Maintenance
- 6.1 Oil Light Reset
- 6.2 Electronic Parking Brake (EPB) Service
- 6.3 Battery Replacement (BRT)
- 6.4 Diesel Particulate Filter (DPF) Regeneration
- 6.5 Throttle Body Alignment (TPS/TBA)
- 6.6 Steering Angle Sensor (SAS) Calibration
- 6.7 Continuous Variable Transmission (CVT)
- 6.8 Gear Learning
- 6.9 Tire Pressure Monitoring System Programming
- 6.10 Injector Coding
- 6.11 ABS Bleeding
- 7 Data Manager
- 8 VCI Manager
- 9 Registration and Update
- 10 Settings
- 11 My Account
- 12 Remote Support
- 空白页面
16
Automotive Diagnostic Platform GT75 User's Manual V1.01
3.3 Establishing Vehicle Communication
To establish communication with GT75:
1. Connect the VCI dongle to the vehicle’s DLC for both communication and
power source.
2. Connect the VCI dongle to the GT75 tablet via Bluetooth or USB
connection.
Figure 3-1 Sample Bluetooth Communication Screen
Figure 3-2 Sample USB Communication Screen
Please refer to Chapter 3.3.1.1 about the details of how to connect via
Bluetooth and Chapter 3.3.1.2 about the details of how to connect via
USB cable.
3. Check the VCI Indicator status at the toolbar. If the button turns to green,
the GT75 is ready to start vehicle diagnosis.