User's Manual
Table Of Contents
- One-Year Limited Warranty
- Safety Information
- Safety Message Conventions Used
- Important Safety Instructions
- 1 Using This Manual
- 2 Introduction
- 3 Getting Started
- 4 Vehicle Identification
- 5 Diagnosis
- 6 Maintenance
- 6.1 Oil Light Reset
- 6.2 Electronic Parking Brake (EPB) Service
- 6.3 Battery Replacement (BRT)
- 6.4 Diesel Particulate Filter (DPF) Regeneration
- 6.5 Throttle Body Alignment (TPS/TBA)
- 6.6 Steering Angle Sensor (SAS) Calibration
- 6.7 Continuous Variable Transmission (CVT)
- 6.8 Gear Learning
- 6.9 Tire Pressure Monitoring System Programming
- 6.10 Injector Coding
- 6.11 ABS Bleeding
- 7 Data Manager
- 8 VCI Manager
- 9 Registration and Update
- 10 Settings
- 11 My Account
- 12 Remote Support
- 空白页面
33
Automotive Diagnostic Platform GT75 User's Manual V1.01
5.1.1 Quick Scan
Quick Scan performs an automatic system test to determine which control
modules are installed on the vehicle and provides diagnostic trouble codes
(DTCs) overview. Depending on the number of control modules, it may take a
few minutes to complete the test.
To perform an automatic system scan:
1. Press Quick Scan option to start.
2. To pause the scan, press the Pause button on the screen.
Figure 5-3 Sample Quick Scan Screen
3. At the end of successful automatic controller scan, a menu with a list of
DTC displays and click button to the right to view DTC descriptions.
Figure 5-4 Sample Quick Scan Complete Screen
4. Press Report to create an overview of installed control units and their
system status, or press Save to save the report. Press Erase to clear the
information.