User Manual
Table Of Contents
- One-Year Limited Warranty
- Safety Information
- 1 Using This Manual
- 2 Introduction
- 3 Getting Started
- 4 OBDII/EOBD Operations
- 5. DTC Lookup
- 6 Review Data
- 7 System Setup
- 8 Tool Information
- 9 NT Wonder Introduction
NT301 OBDII/EOBD Code Reader User’s Guide_English Version_V1.00
35
●
Reset Factory Default
There are two different types of monitors: continuous and non-continuous. Continuous monitors
are different in design from the non-continuous monitors. Continuous monitors are being
constantly tested and evaluated by the car’s computer while the car is running. Conversely, the
non-continuous monitors require certain conditions to be met before a test or series of tests can
be completed.
Continuous Monitors:
●
Misfire
●
Fuel System
●
Comprehensive Component
Non-Continuous Monitors:
NOTE
Non-continuous monitors are different for spark ignition cars (gasoline engines) and compression
ignition card (diesel engines).
Spark ignition vehicles (Gas)
●
Catalyst (CAT)
●
Heated Catalyst
●
Evaporative (EVAP) System
●
Secondary Air System
●
Oxygen (O2) Sensor
●
Oxygen Sensor Heater
●
EGR (Exhaust Gas Recirculation) and/or VVT System
Compression ignition vehicles (Diesel)
●
NMHC Catalyst
●
NOx/SCR After treatment
●
Boost Pressure
●
Exhaust Gas Sensor
●
PM Filter
●
EGR and/or VVT System
To configure monitors:
1. Use the UP/DOWN key to highlight Configure Monitors from Setup menu and press the
ENTER key to confirm.
Figure 7-3 Sample Setup Screen
2. A screen with the optional monitors to be configured displays.