User's Manual

21
PTS1000 User's Manual V1.1
1. Keep the distance between the sensor to be programmed and the
PTS1000 tool at 0~20cm;
2. The distance between other sensors and the PTS1000 tool should be kept
more than 100cm;
3. The disassembled old sensor needs to be kept away from the vehicle.
3.2.1 Manual Create ID
According to the original sensor format, it automatically defaults to decimal or
hexadecimal. The format can also be modified as needed. The input box
placeholder shows the length/digits of the ID. It is recommended to manually
input the "original sensor ID" so that after the sensor programming is
performed, you can directly install the tire for road test without performing the
"sensor relearn function". Only one sensor can be programmed at a time
when manually created.
Figure 3-10 Sample Manual Create ID-Enter ID Interface
Figure 3-11 Sample Manual Create ID-Confirm ID Interface