User's Manual
Table Of Contents
- One-Year Limited Warranty
- Safety Information
- Safety Message Conventions Used
- Important Safety Instructions
- 1 Using This Manual
- 2 Introduction
- 3 Getting Started
- 4 Vehicle Identification
- 5 Diagnosis
- 6 Maintenance
- 6.1 Oil Light Reset
- 6.2 Electronic Parking Brake (EPB) Service
- 6.3 Battery Replacement (BRT)
- 6.4 Diesel Particulate Filter (DPF) Regeneration
- 6.5 Throttle Body Alignment (TPS/TBA)
- 6.6 Steering Angle Sensor (SAS) Calibration
- 6.7 Continuous Variable Transmission (CVT)
- 6.8 Gear Learning
- 6.9 Tire Pressure Monitoring System Programming
- 6.10 Odometer
- 6.11 Injector Coding
- 6.12 ABS Bleeding
- 6.13 Key Programming/Immobilizer
- 7 Data Manager
- 8 VCI Manager
- 9 Registration and Update
- 10 Settings
- 11 Shop Manager
- 12 My Account
- 13 Remote Support
- 14 Technical Data
20
Premier Diagnostic Platform II i80 User's Manual V1.01
Figure 3-6 Sample VCI Indicator Status Screen
NOTE
If the VCI Indicator isn’t green, it indicates that the signal strength of the
transmitter is too weak to be detected. In this case, try to get closer to the
device, or check the connection of VCI dongle, and remove all possible
objects that cause signal interference
3.3.1.2 USB Communication
The USB connection is a simple and quick way to establish communication
between the tablet and the VCI dongle. Connect the dongle and tablet with
the USB Type B cable, and the VCI Indicator will turn green, indicating the
dongle has connected to the tablet.
3.4 Screen Layout of Home Screen
When the tablet boots up, press the i80 desktop icon to launch the diagnostic
application.
Figure 3-7 Sample Home Screen
1. Application Menu
2. Navigation Toolbar