User's Manual
Table Of Contents
- One-Year Limited Warranty
- Safety Information
- Safety Message Conventions Used
- Important Safety Instructions
- 1 Using This Manual
- 2 Introduction
- 3 Getting Started
- 4 Vehicle Identification
- 5 Diagnosis
- 6 Maintenance
- 6.1 Oil Light Reset
- 6.2 Electronic Parking Brake (EPB) Service
- 6.3 Battery Replacement (BRT)
- 6.4 Diesel Particulate Filter (DPF) Regeneration
- 6.5 Throttle Body Alignment (TPS/TBA)
- 6.6 Steering Angle Sensor (SAS) Calibration
- 6.7 Continuous Variable Transmission (CVT)
- 6.8 Gear Learning
- 6.9 Tire Pressure Monitoring System Programming
- 6.10 Odometer
- 6.11 Injector Coding
- 6.12 ABS Bleeding
- 6.13 Key Programming/Immobilizer
- 7 Data Manager
- 8 VCI Manager
- 9 Registration and Update
- 10 Settings
- 11 Shop Manager
- 12 My Account
- 13 Remote Support
- 14 Technical Data
50
Premier Diagnostic Platform II i80 User's Manual V1.01
2. Select Service option from the Special Functions menu. A list of available
services display.
Figure 5-30 Sample Special Functions Screen
3. Select the service you want to perform. Follow on-screen instructions to
make proper selections and operations to complete the tests.
Figure 5-31 Sample Service Function Screen
5.3.2 Coding and Programming
i80 allows for the coding and programming of a replacement control module
or changing previously stored incorrect coding.
Coding also is known as Teach-in Program or Component Adaptation. It is
the process of selecting and activating one program for a specific vehicle
from a set of programs that the factory installed in the control module. This
allows one control module to be used for different models, countries, and
emission applications.
Programming is the process of taking a blank control module and then adding
the correct vehicle program to memory.
To start a coding & programming test:
1. Select Special Functions from main menu and press ENTER to confirm.