User Manual

3D FPV camera The BlackBird 2
User manual
7
2016
fpv3dcam.com
1.5. Desing and operation
The basis of the BlackBird 2 are two video sensor and optical system. The signal from
the video sensor is processed in the FPGA chip, where the signal is generated in the
required 3D format. Further there is a digital-to-analog conversion and the signal is
transmitted to the interface, the modular connector and a mini USB port of your
camera.
1.6. Adjustment instrument, tools and accessories
The main tool that is required for camera maintenance - phillips screwdriver. It is used
when setting the vertical displacement and focusing the lenses. You can use it to
loosen the screws that hold the lenses and their holders.
Optional accessories:
 Pencil for cleaning lenses. It is used to clean the lenses from contamination (see
Figure 3). The flat side of the stick used for cleaning the lens from dirt. A brush is
used to clean the dust from the lenses
 A special table is used for measuring the resolution of the instrument. For
example, EIA1956 or others authorized for at least 600 TVL (see Picture 4)
Picture 3
Picture 4
2. Intended use
2.1. Operating limitations
 The camera operating temperature ranges from - 30 to +50 degrees Celsius. If
the use at different temperatures is planned, it is necessary to arrange extra
cooling or heating to provide the allowed temperature;
 The BlackBird 2 comes in a frameless design and is not protected against
moisture. Protection class IP50 sensors, protection class IP00 for the other
components. For use in a moist environment it must be protected from
moisture;
 The BlackBird 2 is not protected against static electricity. When working with
the BlackBird 2 it is necessary to take measures to protect your camera from
static electricity;
 When operating the BlackBird 2 it is possible that the camera heats up to a
temperature of about 50 degrees Celsius;