Operation Manual

SAFETY WARNINGS
The product must be installed only by qualified persons, according to the local safety standards and
regulations.
It is classified as Class II, in accordance with EN 60950-1.
Installation warnings
- Use only the original power cable, installing the product so that the mains plug is easily accessible.
- The product must not be exposed to dripping or splashing and thus it shall be installed indoors, in a
dry place.
- Leave enough space around the product housing to ensure sufficient ventilation. An excessive
operating temperature and/or an excessive heating may affect the performance and the life of the
product.
- Don’t install the product above or close to heat sources, in dusty places or where it might come into
contact with corrosive substances.
- Humidity and condensation could damage the product. In case of condensation, wait until the
product is dry before using it.
Important: Only instructed and authorized persons can open the product. In case of failure, do not try to
repair the product; otherwise the guarantee will no longer be valid.
Safety measurements