Installation Manual

Made in USA
Installation Instructions
1. The surface temperature of the frame must be above 50º F. for the adhesive
to bond.
2. Clean frame with clean wipe provided to remove dust, oil, grease and dirt.
Wax coated or high gloss painted surfaces may require roughening of the
surface with a scotch brite pad or sandpaper so adhesive will properly bond.
3. Measure and pre-cut pieces to fit the head and jambs.
4. Remove protective backing 1 to 2 feet at a time.
5. Position on frame where illustrated, allowing approximately 1/16'' between
seal and frame for clearance when compressed.
6. Adhere by pressing firmly (approx. 15 lbs. pressure required) straight down
along entire length of gasketing. Do not remove and relocate.
WARNING: Do not rub along length from one end toward other end during
installation as gasket will stretch and not adhere properly.
7. Make sure the seal does not impede proper closing and latching of the door.
HEAD &
LATCH JAMB
FRAME STOP
FRAME STOP
HINGE JAMB
DOOR
DOOR
5050B-17'
1/2"
1/4"
Self Adhesive Silicone Seal
UL Tested and Certified for
Fire and Smoke Doors
STORAGE AND SHELF LIFE
The adhesive on this seal has a shelf
life of one year stored at 75
°F and
50% relative humidity or less
10C
S
NGP-EDGE
®
Sealing System (Category G) for use on
category B wood type fire doors rated up to 20 minutes, single
swing up to 4’0” x 8’0” and pairs up to 8’0” x 8’0”
ESS
* Seals against smoke, fire, air, sound and weather
* Unaffected by sunlight, ozone and ultraviolet rays
* Excellent compression; door latches easily
POSITIVE PRESSURE TESTED GASKETING MATERIALS FOR FIRE DOORS. FOR APPLICATION TO HOLLOW-MET-
AL-TYPE FIRE DOORS, RATED UP TO 3 HOURS AND WOOD-TYPE FIRE DOORS, RATED UP TO 1-1/2 HOURS.
CATEGORY H
FOR APPLICATION TO CATEGORY B WOOD-TYPE FIRE DOORS RATED UP TO 20 MIN.
CATEGORY G, H
Smoke & draft control gasketing (Category H) tested to UL 1784; meets requirements of NFPA 105, IBC for use on “S” label doors.
2.15