Operation Manual

Frama Matrix F32/F42/F62
25
4.3.6.2. Using mail item weight for postal rate calculation
In the detailed overview or the postage rate calculation, press the Weight key
and, at any time, by pressing the Scales 17g key, you can retrieve the weight
displayed for calculating the postage rate.
Caution The procedure described is possible only in STACK mode.
An analogue balance is displayed in the top section of the screen. This shows
you roughly how much of the weight category your mail item is using.
4.3.6.3. STACK/SINGLE weighing mode
Stack weighing mode, with its two variants, is a special feature. Switch the stack weighing mode
between Stack and Single in the Main Menu under Devices and in the Setup 3 menu (see page 55).
STACK mode (default)
Place a stack of letters on the scales (it is recommended that they are pre-
sorted by format). The total weight of the stack will be shown in the top sec-
tion of the display. Select a OneTouch key the content of which is nearest to
the mail items in the stack.
Take a letter from the stack. The display changes to stack weighing mode.
The Weight key provides information as to the weight of the mail item re-
moved from the scales (here: Stack 8g). The postage is calculated on the ba-
sis of this weight. Frank the letter.
Take the next letter from the stack. The weight of the letter is displayed and the postage calculated
accordingly and so on. Once you have removed the last letter from the stack, the stack weighing
mode is quit after 3 seconds.
You still have access to the type of mailing, format, destination and additional services when you
are in the stack weighing mode. A balance shows you how much of the weight category you are
using. If it is necessary to adjust further details (e.g. the format) because of the weight, the balance
flashes red twice before the postage rate is automatically adjusted.
Tip!
You may switch between the STACK or the SINGLE mode using the „Stack“ or the „Single“
buttons during scale operation .