Installation & Assembly

Table Of Contents

Forming the canopy dome:

Step 1: In an open area, position the canopy so that the inside of the canopy (with canopy supports showing) is

facing up.

Step 2: Manually expand the canopy spokes evenly in each direction as much as possible.

Step 3: Using your foot, step on the center hub of the canopy to invert and lock the supports in place. The canopy

will ‘flip’ into its proper convex shape and become stable. (fig.1)

Installing the telescoping support poles:

Step 1: Unlock the clamps on bottom two

telescoping support pole and extend the

pole to its full length. Lock the clamps to

hold in place. (fig.2)

Step 2: Remove existing caps from anchor or

stacking joints. Replace with adapter caps

that have holes to receive the poles. (fig.3)

Step 3: Insert widest end of telescoping support

pole into recess of stacking joint stake.

Repeat with remaining poles. (fig.4)

Note: Before installing the canopy, ensure all angles of the sandbox are equal. (90º for the square sandbox. 120º for

the hexagon sandbox)

Canopy Instruction Manual

(fig2)

(fig.1)

(fig.3) (fig.4)

90º

PAGE 1
Canopy Instruction Manual Forming the canopy dome: Step 1: In an open area, position the canopy so that the inside of the canopy (with canopy supports showing) is facing up. Step 2: Manually expand the canopy spokes evenly in each direction as much as possible. Step 3: Using your foot, step on the center hub of the canopy to invert and lock the supports in place. The canopy will ‘flip’ into its proper convex shape and become stable. (fig.1) (fig.
PAGE 2
Attaching the canopy: (Note: This is easiest with two people) Step 1: Position canopy top so that canopy connectors are aligned with support poles. (fig.5) Step 2: Insert support pole into canopy connector cap. Repeat with remaining poles. (fig.5) Step 3: Extend the top telescoping to its full length. Step 4: Pull canopy flaps together at each corner and affix with Velcro tabs.