FFPD100 SERIES Swivelling spout faucet with spray head Installation guide
ENGLISH TECHNICAL DATA · Minimum working pressure 0,5 bar · Maximum working pressure 5 bar · Recommended working pressure 3 bar (in case of water pressure higher than 5 bar it is recommended to install pressure reducers) · Maximum working temperature 70°C G 01648 G 01735 G 28734.XX G 01646 G 01156 G 01418.XX G 01561.XX G 01431.XX G R0171.XX G R0593 G R0338031 G 1561.XX G R0171.XX G 01156 G R0338031 G R0593 G 01735 G 01648 G 28734.XX G 01431.XX G 01646 G 01418.
ENGLISH Faucet installation lease remove all components from package and inspect prior to P installation (see itemized table and picture). NOTE: Call us immediately if you see inconsistencies. (1-800-626-5771) or visit www.frankeksd.
ENGLISH 2. Remove all mounting hardware from protecting plastic bag. 3. Place the large O-ring over the faucet shank and place the faucet into the desired location. NOTE: the rubber O-ring should be sitting on top of the countertop and between the faucet body. DO NOT use putty or other sealant at this location 4.
ENGLISH 7. The body can be fixed both onto the wall and on surface: . 1. Screw the fixing rail onto the single lever body. 2. Insert it completely in the given plate. 3. Place the single lever body into the sink hole made at a certain distance from the wall. 4. Place the plate properly where it has to be fixed, making sure the drilling points on the wall are well marked corresponding to the two holes with a 28 mm [1-1/8”] interaxe. 5. Place the dowels in the holes. 6.
ENGLISH Standard maintenance and trouble shooting Cleaning of the spray head Any deposits which may accumulate on the nozzle can be removed by simply running a finger over the rubber extrusions and then running the water for a few seconds. In extreme cases this step may have to be repeated. Replacing the Cartridge 1. Shut off the water supply to the faucet. 2. Open the faucet briefly to relief any pressure inside the faucet. 3. Move the faucet handle to the “OFF” position. 4.
ENGLISH Replacing the Headvalve 1. Shut off the water supply to the faucet. 2. Open the faucet briefly to relief any pressure inside the faucet. 3. Move the faucet knob to the “OFF” position. 4. Use a the provided allen key to loosen the set screw which is accessible from the back of the handle. 5. Lift the handle from the headvalve. 6. Unscrew then the headvalve using a 17 mm wrench and replace it. 7. Reinstall all the details, proceeding in opposite order.
ENGLISH Limited lifetime warranty Franke Consumer Products, Inc., Kitchen Systems Division extends the following warranty to the original purchaser of its faucets effective January 1, 2003. All faucets installed in a private residence will carry a limited lifetime warranty on all mechanical parts to be free of manufacturing defects in material and workmanship under normal usage.