Installation Guide

Installation
6
7
Install fastening set as shown: Rubber
Washer, Metal Mounting Washer,
Mounting Nut.
Connect the cold water supply to the
faucet:
•Slide the plastic ferrule and the com-
pression nut onto the blue ¼” poly-tub-
ing and place the plastic insert in the end
of the tubing as illustrated.
•Insert the assembled tubing into the
mounting nipple and tighten the com-
pression nut
•Connect the reducing union to the 1/4”
blue poly-tubing and insert the 3/8”
black poly-tubing.
NOTE: There should be a service label
attached to the black poly-tubing. Be
sure to orient the tubing so the label is
visible after assembly
– DO NOT REMOVE LABEL.
Metal Washer
Rubber Washer
Mounting Nut
Mounting
Nipple
Plastic
Insert
1/4” Blue
Tubing
Reducing
Union
Compression
Nut
1/4” Blue
Tubing
3/8” Black
Tubing
Plastic
Ferrule
5
8
Connect the black 3/8” poly-tubing to the outlet of the filtration system as
outlined in the filtration system instructions.