Installation Sheet

LIMITED LIFETIME WARRANTY
All faucets installed in a private residence will carry a limited lifetime
warranty on all mechanical parts to be free of manufacturing defects
in material and workmanship under normal usage. All chrome finishes
carry a limited lifetime warranty; all other finishes are warranted for
five (5) years form the original date of purchase.
Marine and Outdoor Installation
This warranty applies only to the original owner, providing the product
has been installed in accordance with our installation instructions,
used as recommended and in a normal residential application. In the
event of a warranty claim, the owner will be required to provide proof
of purchase - save sales receipt. This warranty covers all components
which make the product operational. Franke, at its option, may repair
or replace the product or components necessary to restore the pro-
duct to good working condition. Franke reserves the right to inspect
the installation prior to the actual replacement of the product or com-
ponent part. This warranty does not cover misuse or abuse, acciden-
tal damages, scuffs or scratches, improper installation, abnormal
usage, negligence or damage caused by improper maintenance or
cleaning. Normal wear of parts is excluded from the warranty.
Damage caused by impurities or acts beyond our control are not
covered.
Any product or part which has been repaired or altered in
any manner outside of Franke's factory, unless previously authorized
in writing by Franke, will void warranty. Any replacement excludes
transportation and any labor re-installation costs. This warranty
does not allow recovery of incidental or consequential damages such
as loss of use, delay, property damage or other consequential dama-
ge, and Franke accepts no liability for such damages.
The Franke warranty is limited to the above conditions and to the
warranty period specified herein and is exclusive. Franke DISCLAIMS
all other warranties, expressed or implied, including IMPLIED
WARRANTIES OF MERCHANTABILITY AND/OR FITNESS
FOR A PARTICULAR PURPOSE. This warranty gives you
specific legal rights that may vary from state to state.
Further information
For any further information about our products, about the installation of
REV.1.07/2016 IISTRFL96824/3V#C08960
STANDARD MAINTENANCE AND TROUBLESHOOTING
REPLACING THE MIXING CARTRIDGE
1. Shut o the water supply to the faucet.
2. Turn on the faucet briey to relieve any pressure inside the faucet.
3. Remove cap C from the lever handle A and remove the screw B using
allen key.
4. Remove the handle A from the faucet body.
5. Unscrew the cap D .
6. Unscrew the cartridge lock nut E.
7. Lift ceramic disk cartridge F from the body and replace it with new
cartidge. Ensure the two lugs on bottom of the cartridge sit properly
GENERAL MAINTENANCE
Clean aerator periodically for any buildup .
Do not use harsh detergents, solvents, chemical agents, metallic sponges,
etc. that could harm the surface and damage the nish.
Clean only with a soft sponge and soapy water.
INSTALLATION MANUAL
FFT3100 - FFT3180
Franke Kitchen Systems
800 Aviation Parkway
Smyrna, TN 37167, USA
Phone: [phone]
Email: [e-mail]
FILTERED
WATER
SPARE / REPLACEMENT LIST
F3101*A+B+C+G Mixer Handle assembly
H+B1+C+G1 Filtered water handle assembly FT3101*
D. Cap F2902*
E. Lock nut F2903
F. Cartridge F2904
I. Filtered water valve FT3102
J. Aerator assembly
K+L+N
Mounting hardware kit
FT3103*
F3110
M. Supply hoses
O. Filtered water supply hose
FT3104
P. Shut o valve
CH chrome
SN satin nickel
in the allocated holes at the base of the body.
8. Reassemble faucet in reverse order and test for leakage.
A
D
E
F
G
B
B1
C
C
H
I
J
K
L
M
N
O
P
Q
Q. 3/8” Poly Tubing
G1
FT3105
10306
10305
*Must specify nish
Franke Kitchen Systems,LLC extends the following warranty to
the original purchaser of its faucets effective January 1, 2003.
warranted for Marine and Outdoor installations.
: Franke faucets are NOT
them or about the guarantee, please contact our customer service
department:
REPLACING THE FILTERED WATER VALVE
1. Shut o the water supply to the faucet.
2. Turn on the faucet briey to relieve any pressure inside the faucet.
3. Remove cap C from the handle H and remove the screw B1 using an
allen key.
4. Remove handle H from the faucet body .
5. Use 20 mm socket to unscrew valve from faucet body and replace
with new valve, tighten new valve , DO NOT exceed 177 in-lbs of torque.
6. Reassemble faucet in reverse order and test for leakage.
See Installation section for hose replacement diagram .
AMBIENT FILTER 3-1