Installation Guide

STEP 2:
OPTION A: Prepare existing countertop
Make sure existing countertop cut-out opening is the proper size. Set the new sink
into opening. Caution: do not push the sink tight to the countertop at this time. The
sink rim should rest evenly on the countertop. Slight adjustments can be made using
a file or a jigsaw.
Use caution to avoid chipping or cracking the countertop while fi ling or sawing.
Countertop should not be warped in order for sink to fit flush in the opening.
1.
2.
3.
Carefully place the sink upside down on the
countertop at the desired position. Trace the
outline of the sink onto the countertop. Do not
cut along this line.
Draw a line 1/2” (12.7mm) inside the sink outline.
Measure the cut-out line you just drew and
compare to all sink dimensions. The cut-out
should be approximately 1” (25.4mm) smaller
than the overall sink dimensions.
Verify both measurements.
Drill a pilot hole inside the cutting line.
Using a jigsaw, cut along the inside line to create the opening in the countertop.
1.
2.
3.
4.
5.
Measure the cut-out line and compare to all sink
dimensions. The cut-out line should be 1” (25.4mm)
smaller than the overall sink dimensions.
Place template on countertop. Trace completely
around the edge of the template directly onto
your countertop.
Drill a pilot hole inside the cutting line.
Using a jigsaw, cut along the line to create
the opening in the countertop.
1.
2.
3.
4.
1.
2.
3.
Attach faucet and drains to the sink. Use plumber’s putty or silicone sealant under
the faucet base and under the top flange of the drain to provide a leak-proof seal.
OPTION B: Prepare a new countertop
using the sink as a template
OPTION C: Prepare a new countertop
using the cut-out template provided
STEP 3: Install accessories
STEP 4: Apply the mounting clips
OPTION C: 1
2
43
OPTION B: 1
4
2
5
Step 3
Step 2
Countertop
Sink
Step 4
Turn sink upside down onto a clean, soft surface.
Attach clips to the mounting slots in the sink rim. Ensure clip jaws are facing the
outside edge of sink.
Verify clip snaps are fully seated into the mounting slot.