Installation Guide

Connect and tighten hot and cold faucet supply lines, strainer, drain and trap assembly. Note: Depending on the
location of sink drain holes, it may be necessary to adjust the drain pipe fittings under the sink to accommodate
the new sink installation.
Turn on water supply and examine all connections for leaks. If leak appears, tighten joint slightly. Do not overtighten.
With stopper in place, fill sink and examine area under sink and around drain flange for leaks.
Remove stopper and let water drain while examining drain connections for leaks.
1.
2.
3.
4.
Locate the position of the sink using the template provided
and make the cut-out from the countertop. Note: This
template will align the edge of the countertop to the
tangent of the top radius of the bowl (see illustration).
If there is a preference to show more reveal of sink flange
(lip), adjustments to the cut out need to be made by installer.
STEP 6: Final Steps
STEP 1: Determine position of the sink
Align the bowl under the countertop cut-out and determine
the location for the mounting brackets. Mounting brackets
have been supplied. Installer will determine attachment
method.
STEP 2: Determine position of the
mounting brackets
Attach the mounting brackets loosely to the countertop
from underneath, using the fastener and attachment method
recommended by the countertop supplier.
STEP 3: Attach the mounting brackets
Apply a continuous bead around the top flange (lip) of the sink.
STEP 4: Apply silicone sealant or plumber’s putty
Undermount Installation
Place template on
countertop & co
rm where
to cut hole.
Countertop
Cabinet
Template
Step 1
Mounting bracket
(provided)
Wing nut & washer
(not provided)
Countertop
Epoxy
Silicone sealan
t
(not provided)
Sink
Step 2-5
STEP 5: Insert sink and tighten mounting clips
With sink in the upside-down position, place a continuous
and generous bead of silicone sealant or plumber’s putty
around the entire perimeter of the rim. This serves as a
watertight seal.
Position clips to position 1 back as noted in diagram in
order to prepare for inserting sink into countertop.
Lift sink, turn face-up and lower into the countertop opening.
Line up front rim with the front edge of the counter.
Return clips to position 2 for tightening.
Underneath the countertop, begin tightening clips with a
screwdriver in an even fashion, alternating sides while tightening until the entire rim is sealed.
6
2
Step 5-6
Step 5-2
5
Step 5-5
Apply a bead of silicone
sealant or plumberʼs putty
around the rim.
Slowly tighten
the clip with
a screwdriver.
Countertop
Countertop
Countertop
Sink Sink
Countertop
1.
2.
3.
4.
5.
6.
Step 5-1