Specification

Decorative Grab Bars
MATERIALS: 5600 (1-1/2" O.D.) and 5700 (1-1/4" O.D.) tubing is (18 gauge) type 304 stainless steel with #4 satin finish. Wall Flanges
are (14 gauge) type 304 stainless steel. Snap lock cover flanges are (20 gauge) stainless steel with #4 satin finish.
Wall flanges are heliarc welded to tubing.
INSTALLATION: Install grab bar with 3 - #10 x 2-1/2" pan head stainless steel screws provided for each end wall flange and 2 - #10 x 2-1/2" pan head
stainless steel screws provided for each center wall flange. Slide cover flanges over wall flanges and press firmly to complete installation.
OPTIONAL FASTENER INFORMATION:
Wood blocking is preferable behind all wall surfaces. If wood blocking is not available, the following fasteners are suggested:
Tile/Masonry - Plastic or Lead Anchors, Plaster/Drywall - Toggle Bolts.
Note: 5600 and 5700 series grab bars are engineered to meet 1000 lb. pull (500 lb. pull for 5700PB series) when properly installed.
5600 and 5700 series meet ADA, and ANSI (A117.1-2003) for form and load bearing requirements.
SPECIFICATION: Surface mounted grab bar shall be model__________________________
(fill in model number) by Liberty Hardware Manufacturing Corporation.
18 in. x 1-1/4 in. GRAB BAR
TECHNICAL DATA
2-1/6"
52 mm
3" DIA
76 mm
1-1/2"
38 mm
Grab Bars
5600 & 5700 Series
"A"
Dimensions shown are flange
center to center distance.
5748
5648
48"
(1219 mm)
57425736573257305724571857165712
56425636563256305624561856165612
42"
(1066 mm)
36"
(914 mm)
32"
(812 mm)
30"
(762 mm)
24"
(609 mm)
18"
(457 mm)
16"
(406 mm)
12"
(305 mm)
SERIES
DIM "A"
NO.
1-1/4" O.D.5700
1-1/2" O.D.
5600
20.75"
527.1 mm
2.98"
75.6 mm
1.5"
38.1 mm
18"
457.2 mm
MATERIALS: Grab bar is constructed using 1-1/4" diameter 18 gauge 304 stainless steel tubing. Decorative posts and trim rings are cast in zinc.
Trim rings are held in place using a friction fit over an O-ring. Meets ADA and ANSI A117.1-2003 for form and
load bearing requirements.
INSTALLATION: Install grab bar with 3 - #10 x 2-1/2” flat head stainless steel screws provided for each end wall flange. Slide cover flanges over wall
flanges and press firmly to complete installation.
OPTIONAL FASTENER INFORMATION:
Wood blocking is preferable behind all wall surfaces. If wood blocking is not available, the following fasteners are suggested:
Tile/Masonry - Plastic or Lead Anchors, Plaster/Drywall - Toggle Bolts.
SPECIFICATION: Surface mounted grab bar shall be model ____________________________
(fill in model number) by Liberty Hardware Manufacturing Corporation.
Liberty Hardware Manufacturing Corporation • 140 Business Park Drive • Winston-Salem, NC 27107 • 800.542.3789 • www.libertyhardware.com
©2009 LHMC, A Masco Company