User's Manual

Page 38 / 48 Copyright © 2013 Franklin Wireless Corp.
Time Menu (Option 3)
Auto send time
(Option ##31)
- You can select an auto-send time.
- There are 10 options (Please see the chart below).
- After selecting a desired auto-send time, press ‘’ to save.
- If you press ‘#’, the saved auto-send time will be cancelled and revert back to default auto-send time of 3 seconds.
Time table:
1
2
3
4
5
6
7
8
9
0
1
second
2
seconds
3
seconds
4
seconds
5
seconds
6
seconds
7
seconds
8
seconds
9
seconds
10
seconds
Flash time
(Option ##32)
- In the Flash time menu, you can change flash time from 50 to 999 ms (default: 100 ms).
- You cannot set a flash time bigger than on-hook time. If you need to do so, please first adjust on-hook time prior to
adjusting the flash time (see on hook options below).
- Press ‘’ to set. Or press ‘#’ to cancel.
*NOTE: If the entered flash time or on hook time is out of range, it will be ignored.
Ex) ##32 + 300 +  : to set the flash time to 300 ms
On-Hook time
(Option ##33)
- In the On-Hook Time menu, you can change the on hook time from 101 to 1000ms (default : 1000 ms).
- Any time entered out of range, will be ignored.
- You cannot set smaller on hook value than the flash time (see flash time above). If you want to do so, please adjust a
flash time first, and then, set the on-hook time
- Press ‘’ to set, Or press ‘#’ to release.
*
NOTE: Any time entered out of range, will be ignored.
Ex)##33 + 500 +  : to set the on hook time to 500 ms