User's Manual

M600C Mobile Broadband Module

automatically whenever you attach it to your computer.

1. Open the Hardware tab of the settings window (Click Tools > Settings > Hardware.).

2. Click the Modify button next to the Mobile Devices heading. The CDMA version of

the Device Properties window appears (see Device Properties Window: CDMA Version).

3. Check the Auto Connect when device is available box.

Note: This feature will behave differently depending on whether RAS or NDIS is selected

in the section below the check box. If RAS is selected, auto connection will occur only if

the Sprint Smart View software is running. If NDIS is selected, auto connection will occur

even if Sprint SmartView is not running.

4. Click OK to exit the settings window.

Your device should now automatically establish a connection each time you connect it to

your computer.

Note: This is one of two auto connect features provided by the Sprint Smart View

software. This feature automatically establishes a connection when you attach a

particular Mobile Broadband device to your computer. It will automatically connect to the

highest priority network regardless of whether the profile for that network specifies auto

connection.

The other feature automatically establishes connections to individual networks based on

the configuration of the corresponding network profiles. This is controlled by the

Connection Options setting on the General page of the profile properties window. The

feature is enabled each time you start Sprint Smart View, but can be disabled by

establishing a connection manually. The feature can be re-enabled by clicking the Auto

button in the main window.